This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

AT91SAM7S32B-AU

ARM Microcontrollers - MCU LQFP IND TEMP MRL B

AT91SAM7S32B-AU General Description

ARM7® SAM7S Microcontroller IC 16/32-Bit 55MHz 32KB (32K x 8) FLASH 48-LQFP (7x7)

Key Features

  • Incorporates the ARM7TDMI® ARM® Thumb® Processor
  • – High-performance 32-bit RISC Architecture
  • – High-density 16-bit Instruction Set
  • – Leader in MIPS/Watt
  • – EmbeddedICE™ In-circuit Emulation, Debug Communication Channel Support
  • Internal High-speed Flash
  • – 512 Kbytes (AT91SAM7S512) Organized in Two Contiguous Banks of 1024 Pages of 256 Bytes (Dual Plane)
  • – 256 Kbytes (AT91SAM7S256) Organized in 1024 Pages of 256 Bytes (Single Plane)
  • – 128 Kbytes (AT91SAM7S128) Organized in 512 Pages of 256 Bytes (Single Plane)
  • – 64 Kbytes (AT91SAM7S64) Organized in 512 Pages of 128 Bytes (Single Plane)
  • – 32 Kbytes (AT91SAM7S321/32) Organized in 256 Pages of 128 Bytes (Single Plane)
  • – 16 Kbytes (AT91SAM7S161/16 Organized in 256 Pages of 64 Bytes (Single Plane)
  • – Single Cycle Access at Up to 30 MHz in Worst Case Conditions
  • – Prefetch Buffer Optimizing Thumb Instruction Execution at Maximum Speed
  • – Page Programming Time: 6 ms, Including Page Auto-erase, Full Erase Time: 15 ms
  • – 10,000 Write Cycles, 10-year Data Retention Capability, Sector Lock Capabilities, Flash Security Bit
  • – Fast Flash Programming Interface for High Volume Production
  • Internal High-speed SRAM, Single-cycle Access at Maximum Speed
  • – 64 Kbytes (AT91SAM7S512/256)
  • – 32 Kbytes (AT91SAM7S128)
  • – 16 Kbytes (AT91SAM7S64)
  • – 8 Kbytes (AT91SAM7S321/32)
  • – 4 Kbytes (AT91SAM7S161/16)
  • Memory Controller (MC)
  • – Embedded Flash Controller, Abort Status and Misalignment Detection
  • Reset Controller (RSTC)
  • – Based on Power-on Reset and Low-power Factory-calibrated Brown-out Detector
  • – Provides External Reset Signal Shaping and Reset Source Status
  • Clock Generator (CKGR)
  • – Low-power RC Oscillator, 3 to 20 MHz On-chip Oscillator and one PLL
  • Power Management Controller (PMC)
  • – Software Power Optimization Capabilities, Including Slow Clock Mode (Down to 500 Hz) and Idle Mode
  • – Three Programmable External Clock Signals
  • Advanced Interrupt Controller (AIC)
  • – Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
  • – Two (AT91SAM7S512/256/128/64/321/161) or One (AT91SAM7S32/16) External Interrupt Source(s) and One Fast Interrupt Source, Spurious Interrupt Protected
  • Debug Unit (DBGU)
  • – 2-wire UART and Support for Debug Communication Channel interrupt, Programmable ICE Access Prevention
  • – Mode for General Purpose 2-wire UART Serial Communication
  • Periodic Interval Timer (PIT)
  • – 20-bit Programmable Counter plus 12-bit Interval Counter
  • Windowed Watchdog (WDT)
  • – 12-bit key-protected Programmable Counter
  • – Provides Reset or Interrupt Signals to the System
  • – Counter May Be Stopped While the Processor is in Debug State or in Idle Mode
  • (Continue .)

Specifications

Source Content uid AT91SAM7S32B-AU Pbfree Code Yes
Part Life Cycle Code Obsolete Reach Compliance Code compliant
ECCN Code 3A991.A.2 HTS Code 8542.31.00.01
Has ADC YES Additional Feature ALSO REQUIRES 3.3V SUPPLY
Address Bus Width Bit Size 32
Clock Frequency-Max 55 MHz DMA Channels YES
External Data Bus Width JESD-30 Code S-PQFP-G48
Length 7 mm Number of I/O Lines 21
Number of Terminals 48 On Chip Program ROM Width 8
Operating Temperature-Max 85 °C Operating Temperature-Min -40 °C
PWM Channels YES Peak Reflow Temperature (Cel) 260
RAM (bytes) 8192 ROM (words) 32768
ROM Programmability FLASH Seated Height-Max 1.6 mm
Speed 20 MHz Supply Voltage-Max 1.95 V
Supply Voltage-Min 1.65 V Supply Voltage-Nom 1.8 V
Surface Mount YES Technology CMOS
Temperature Grade INDUSTRIAL Terminal Form GULL WING
Terminal Pitch 0.5 mm Terminal Position QUAD
Time@Peak Reflow Temperature-Max (s) 30 Width 7 mm
uPs/uCs/Peripheral ICs Type MICROCONTROLLER, RISC

Service Policies and Others

After-Sales & Settlement Related

payment Payment

Payment Method

hsbc
TT/Wire Transfer
paypal
Paypal
wu
Western Union
mg
Money Gram

For alternative payment channels, please reach out to us at:

[email protected]
shipping Shipping & Packing

Shipping Method

fedex
Fedex
ups
UPS
dhl
DHL
tnt
NTN
Packing

AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.

Warranty Warranty

We promise to provide 365 days quality assurance service for all our products.

Reviews

You need to log in to reply. Sign In | Sign Up

Availability: 5355 PCS

+BOM
Qty. Unit Price Ext. Price
1+ - -

The prices below are for reference only.