This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

Images are for reference only,

See Technical Specifications

PIC18F4620

Email: [email protected]

Skype: live:.cid.ab6b29428937b76

Tel: +852 95804164

Up to 10 MIPS Performance at 3V
C compiler optimized RISC architecture
8x8 Single Cycle Hardware Multiply
Internal oscillator support-31 kHz to 8MHz with 4xPLL
Fail-Safe Clock Monitor- allows safe shutdown if clock fails
Watchdog Timer with separate RC oscillator
Wide operating Voltage range; 2.0V to 5.5V
An integrated LCD driver module, capable of driving 48 segments and 4 commons for LCD display (132 pixels)
Run, Idle and SLEEP modes
Idle mode currents down to 5.8uA typical
Sleep mode currents down to 0.1uA typical
10-bit ADC, 12 channels, 100K samples per second
Programmable Low Voltage Detection Module
Programmable Brown-out-Reset Module
Two Analog Comparators
Master Synchronous Serial Port supports SPI™ and I2C™ master and slave mode
EUSART module including LIN bus support
Four Timer modules
Up to 5 PWM outputs
Up to 2 Capture / Compare

Program Memory Size (KB)	64	RAM (bytes)	3968
Data EEPROM (bytes)	1024	Pin Count	40
Operation Voltage Max.(V)	5.5	Operation Voltage Min.(V)	2
Timers	1 x 8-bit - 3 x 16-bit	Max ADC Resolution (bits)	10
ADC Channels	13	Zero Cross Detect	No
Number of Comparators	2	SPI	1 -SPI
I2C	1 -I2C	Stand alone PWM	0
Low Power	No	Numerically Controlled Oscillator (NCO)	0
Data Signal Modulator (DSM)	0