This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

TCA9406DCUR

2-bit bidirectional 1MHz I2C/SMBus voltage level translator with internal pull-up resistor

TCA9406DCUR General Description

The TCA9406 is a 2-bit bidirectional IC and SMBus voltage-level translator with an output enable (OE) input. It is operational from 1.65 V to 3.6 V on the A-side, referenced toVCCA, and from 2.3 V to 5.5 V on the B-side, referenced to VCCB. This allows the device to interface between lower and higher logic signal levels at any of the typical 1.8-V, 2.5-V, 3.3-V, and5-V supply rails.

The OE input pin is referenced to VCCA, can be tied directly to VCCA, but it is also 5.5-V tolerant. The OE pin can also be controlled and set to a logic low to place all the SCL and SDA pins in a high-impedance state, which significantly reduces the quiescent current consumption.

Under normal IC and SMBus operation or other open-drain configurations, the TCA9406 can support up to 2 Mbps; therefore, it is compatible with standard IC speeds where the frequency of SCL is 100 kHz (Standard-mode), 400 kHz (Fast-mode), or 1 MHz (Fast-mode Plus). The device can also be used as a general purpose level translator, and when the A- and B-side ports are both driven with push-pull devices the TCA9406 can support up to 24 Mbps.

The TCA9406 features internal 10-kΩ pullup resistors on SCL_A, SDA_A, SCL_B, and SDA_B. Additional external pullup resistors can be added to the bus to reduce the total pullup resistance and speed up rising edges.

tca9406dcur tca9406dcur

Key Features

  • 2-Bit Bidirectional Translator for SDA and SCL Lines in I2CApplications
  • Provides Bidirectional Voltage Translation With No DirectionPin
  • High-Impedance Output SCL_A, SDA_A, SCL_B, SDA_B Pins When OE = Low orVCC = 0 V
  • Internal 10-kΩ Pullup Resistor on All SDA andSCL Pins
  • 1.65 V to 3.6 V on A port and 2.3 V to 5.5 V on B port (VCCA≤ VCCB)
  • VCC Isolation Feature: If Either VCCInput Is at GND, Both Ports Are in the High-Impedance State
  • No Power-Supply Sequencing Required: Either VCCA orVCCB Can Be Ramped First
  • Low Ioff of 2 μA When Either VCCA orVCCB = 0 V
  • OE Input Can Be Tied Directly toVCCA Or Controlled By GPIO
  • Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
  • ESD Protection Exceeds JESD 22
    • A Port
      • 2500-V Human-Body Model (A114-B)
      • 250-V Machine Model (A115-A)
      • 1500-V Charged-Device Model (C101)
    • B Port
      • 8-kV Human-Body Model (A114-B)
      • 250-V Machine Model (A115-A)
      • 1500-V Charged-Device Model (C101)

All trademarks are the property of their respective owners.

tca9406dcur TCA9406DCUR

Application

  • Voltage Level Translation
  • GPIO Expansion
  • Mixed Voltage Systems
  • I2C Bus Extension
  • Sensor Interfaces
  • Battery-Powered Devices

Specifications

Category Integrated Circuits (ICs)LogicTranslators, Level Shifters Series TCA
Translator Type Voltage Level Channel Type Bidirectional
Number of Circuits 1 Channels per Circuit 2
Voltage - VCCA 1.65 V ~ 3.6 V Voltage - VCCB 2.3 V ~ 5.5 V
Input Signal - Output Signal -
Output Type Open Drain Data Rate 24Mbps
Operating Temperature -40°C ~ 85°C (TA) Features Auto-Direction Sensing
Mounting Type Surface Mount Base Product Number TCA9406
Frequency (max) (MHz) 1 VCCA (min) (V) 1.65
VCCA (max) (V) 3.6 VCCB (min) (V) 2.3
VCCB (max) (V) 5.5 Supply restrictions VCCA <= VCCB
Rating Catalog Operating temperature range (°C) -40 to 85

Service Policies and Others

After-Sales & Settlement Related

payment Payment

Payment Method

hsbc
TT/Wire Transfer
paypal
Paypal
wu
Western Union
mg
Money Gram

For alternative payment channels, please reach out to us at:

[email protected]
shipping Shipping & Packing

Shipping Method

fedex
Fedex
ups
UPS
dhl
DHL
tnt
NTN
Packing

AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.

Warranty Warranty

We promise to provide 365 days quality assurance service for all our products.

Ratings and Reviews

More
B
B**s 04/27/2023

Mounted circuit work all regularly.If you want to get a flashing LED slower you can place a trimmer 1 Mohm instead that's 200 Kohm (Trimmer adjustment RP1).

10

Reviews

You need to log in to reply. Sign In | Sign Up

Availability: 7487 PCS

+BOM
Qty. Unit Price Ext. Price
1+ $0.614 $0.61
10+ $0.501 $5.01
30+ $0.443 $13.29
100+ $0.388 $38.80
500+ $0.354 $177.00
1000+ $0.336 $336.00

The prices below are for reference only.