Payment Method
SN65LVDM051D
Dual LVDS transmitter & receiver
-
Manufacturer:
-
Mfr.Part #:
SN65LVDM051D
-
Datasheet:
-
Type:
Transceiver
-
Protocol:
LVDS
-
Number of Drivers/Receivers:
2/2
-
Duplex:
Full
-
EDA/CAD Models:
Availability: 6921 PCS
Please fill in the short form below and we will provide you the quotation immediately.
SN65LVDM051D General Description
The SN65LVDM179, SN65LVDM180, SN65LVDM050, and SN65LVDM051 are differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve high signaling rates. These circuits are similar to TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts, except that the output current of the drivers is doubled. This modification provides a minimum differential output voltage magnitude of 247 mV across a 50- load simulating two transmission lines in parallel. This allows having data buses with more than one driver or with two line termination resistors. The receivers detect a voltage difference of 50 mV with up to 1 V of ground potential difference between a transmitter and receiver.
The intended application of these devices and signaling techniques is point-to-point half duplex, baseband data transmission over a controlled impedance media of approximately 100 characteristic impedance.
The transmission media may be printed-circuit board traces, backplanes, or cables. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media, the noise coupling to the environment, and other application-specific characteristics.
The SN65LVDM179, SN65LVDM180, SN65LVDM050, and SN65LVDM051 are characterized for operation from 40°C to 85°C.
Key Features
- Low-Voltage Differential 50- Line Drivers and Receivers
- Typical Full-Duplex Signaling Rates of 100 Mbps
- Bus-Terminal ESD Exceeds 12 kV
- Operates From a Single 3.3-V Supply
- Low-Voltage Differential Signaling With Typical
Output Voltages of 340 mV With a 50- Load - Valid Output With as Little as 50-mV Input
Voltage Difference - Propagation Delay Times
- Driver: 1.7 ns Typical
- Receiver: 3.7 ns Typical
- Power Dissipation at 200 MHz
- Driver: 50 mW Typical
- Receiver: 60 mW Typical
- LVTTL Input Levels Are 5-V Tolerant
- Driver Is High Impedance When Disabled or With VCC < 1.5 V
- Receiver Has Open-Circuit Failsafe
Specifications
Category | Integrated Circuits (ICs)InterfaceDrivers, Receivers, Transceivers | Series | - |
Type | Transceiver | Protocol | LVDS |
Number of Drivers/Receivers | 2/2 | Duplex | Full |
Data Rate | 500Mbps | Voltage - Supply | 3V ~ 3.6V |
Operating Temperature | -40°C ~ 85°C | Mounting Type | Surface Mount |
Base Product Number | 65LVDM051 |
Service Policies and Others
After-Sales & Settlement Related
For alternative payment channels, please reach out to us at:
[email protected]Shipping Method
AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.
365-Day Product
Quality Guarantee
We promise to provide 365 days quality assurance service for all our products.
Availability: 6921 PCS
+BOMQty. | Unit Price | Ext. Price |
---|---|---|
1+ | - | - |
The prices below are for reference only.
All bill of materials (BOM) can be sent via email to [email protected], or fill below form to Quote for SN65LVDM051D, guaranteed quotes back within 12hr.
Top Sellers
-
SN65HVD230DR
TI
1000+ $0.403
-
SN75176BP
Texas Instruments
1000+ $0.309
-
PCF8574AN
TI
8-bit 2.5- to 5.5-V I2C/SMBus I/O expander with interrupt
-
MAX232N
Texas Instruments
Dual Transmitter/Receiver RS-232 16-Pin PDIP Tube
-
TCA6424RGJR
Texas Instruments, Inc
24-bit translating 1.65- to 5.5-V I2C/SMBus I/O expander with interrupt, reset & config registers