This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

Images are for reference only,

See Technical Specifications

HV860K7-G

Low Noise Dimmable EL Lamp Driver.

Manufacturer:

Microchip Technology, Inc
Mfr.Part #:

HV860K7-G
Datasheet:

HV860K7-G Datasheet (PDF)
Type:

EL Lamp Driver
Frequency:

40kHz ~ 200kHz
Voltage - Supply:

2.5V ~ 4.5V
Current - Supply:

16 mA
EDA/CAD Models:

Request Free CAD Models for HV860K7-G

Email: [email protected]

Skype: live:.cid.ab6b29428937b76

Tel: +852 95804164

HV860K7-G General Description

HV860 is a high voltage driver designed for driving Electroluminescent, (EL), lamps of up to 5 square inches. The input supply voltage range is from 2.5 to 4.5V. The device uses a single inductor and a minimum number of passive components. Using the internal reference voltage, the regulated output voltage is at a nominal voltage of 110V. The EL lamp will therefore see ±110V. An enable pin, (EN), is available to turn the device on and off via a logic signal.The HV860 has two internal oscillators, a switching MOSFET, and a high voltage EL lamp driver H-bridge. The frequency for the switching MOSFET is set by an external resistor connected between the RSW-Osc pin and the supply pin VDD. The EL lamp driver frequency is set by an external resistor connected between REL-Osc pin and VDD pin. An external inductor is connected between the LX and VDD pins or VIN for split supply applications. A 3.0nF capacitor is connected between CS and ground. The EL lamp is connected between VA and VB. The switching MOSFET charges the external inductor and discharges it into the capacitor at CS. The voltage at CS will start to increase. Once the voltage at CS reaches a nominal value of 110V, the switching MOSFET is turned OFF to conserve power. The outputs VA and VB are configured as an H bridge and are switching in opposite states to achieve ±110V across the EL lamp.EL lamp dimming can be accomplished by changing the input voltage to the VREG pin. The VREG pin allows an external voltage source to control the VCS amplitude. The VCS voltage is approximately 87 times the voltage seen on VREG.

Key Features

Adjustable output regulation for dimming
220VPP output voltage for higher brightness
Single cell lithium ion compatible
150nA shutdown current
Separately adjustable lamp and converter frequencies
3x3mm 12-Lead QFN package
Split supply capability

Microchip Technology, Inc Original Stock

Specifications

Category	Integrated Circuits (ICs)Power Management (PMIC)Lighting, Ballast Controllers	Series	-
Type	EL Lamp Driver	Frequency	40kHz ~ 200kHz
Voltage - Supply	2.5V ~ 4.5V	Current - Supply	16 mA
Current - Output Source/Sink	-	Dimming	Yes
Operating Temperature	-40°C ~ 85°C	Mounting Type	Surface Mount
Base Product Number	HV860