Payment Method
W83697HF +BOM
Multifunction Peripheral, CMOS, PQFP128, PLASTIC, QFP-128
QFP-128-
Manufacturer:
WINBOND ELECTRONICS CORP
-
Mfr.Part #:
W83697HF
-
Datasheet:
-
Part Life Cycle Code:
Obsolete
-
Pin Count:
128
-
Reach Compliance Code:
compliant
-
HTS Code:
8542.39.00.01
-
EDA/CAD Models:
Availability: 7072 PCS
Please fill in the short form below and we will provide you the quotation immediately.
Key Features
- General
- Meet LPC Spec. 1.01
- Support LDRQ#(LPC DMA), SERIRQ (serial IRQ)
- Include all the features of Winbond I/O W83877TF
- Integrate Hardware Monitor functions
- Compliant with Microsoft PC98/PC99 Hardware Design Guide
- Support DPM (Device Power Management), ACPI
- Programmable configuration settings
- Single 24 or 48 MHz clock input
- FDC
- Compatible with IBM PC AT disk drive systems
- Variable write pre-compensation with track selectable capability
- Support vertical recording format
- DMA enable logic
- 16-byte data FIFOs
- Support floppy disk drives and tape drives
- Detects all overrun and under run conditions
- Built-in address mark detection circuit to simplify the read electronics
- FDD anti-virus functions with software write protect and FDD write enable signal (write data signal was forced to be inactive)
- Support up to four 3.5-inch or 5.25-inch floppy disk drives
- Completely compatible with industry standard 82077
- 360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps data transfer rate
- Support 3-mode FDD, and its Win95/98 driver
- UART
- Two high-speed 16550 compatible UARTs with 16-byte send/receive FIFOs
- MIDI compatible
- Fully programmable serial-interface characteristics:
- --- 5, 6, 7 or 8-bit characters
- --- Even, odd or no parity bit generation/detection
- --- 1, 1.5 or 2 stop bits generation
- Internal diagnostic capabilities:
- --- Loop-back controls for communications link fault isolation
- --- Break, parity, overrun, framing error simulation
- Programmable baud generator allows division of 1.8461 MHz and 24 MHz by 1 to (216-1)
- Maximum baud rate up to 921k bps for 14.769 MHz and 1.5M bps for 24 MHz
- Infrared
- Support IrDA version 1.0 SIR protocol with maximum baud rate up to 115.2K bps
- Support SHARP ASK-IR protocol with maximum baud rate up to 57,600 bps
- Support Consumer IR with Wake-Up function.
- Parallel Port
- Compatible with IBM parallel port
- Support PS/2 compatible bi-directional parallel port
- Support Enhanced Parallel Port (EPP) − Compatible with IEEE 1284 specification
- Support Extended Capabilities Port (ECP) − Compatible with IEEE 1284 specification
- Extension FDD mode supports disk drive B; and Extension 2FDD mode supports disk drives A and B through parallel port
- Enhanced printer port back-drive current protection
- Game Port
- Support two separate Joysticks
- Support every Joystick two axes (X, Y) and two buttons (S1,S2) controllers
- MIDI Port
- The baud rate is 31.25 K baud rate
- 16-byte input FIFO
- 16-byte output FIFO
- Flash ROM Interface
- Support up to 4M flash ROM
- General Purpose I/O Ports
- 48 programmable general purpose I/O ports
- General purpose I/O ports can serve as simple I/O ports, watch dog timer output, power LED output, infrared I/O pins, suspend LED output, Beep output
- Functional in power down mode
Specifications
Part Life Cycle Code | Obsolete | Pin Count | 128 |
Reach Compliance Code | compliant | HTS Code | 8542.39.00.01 |
Additional Feature | ON CHIP FDC AND UART | Address Bus Width | 4 |
Boundary Scan | NO | Bus Compatibility | PC-AT; PS/2; LPC |
Clock Frequency-Max | 48 MHz | External Data Bus Width | 4 |
JESD-30 Code | R-PQFP-G128 | JESD-609 Code | e0 |
Length | 20 mm | Number of I/O Lines | 48 |
Number of Terminals | 128 | Operating Temperature-Max | 70 °C |
Operating Temperature-Min | Power Supplies | 3.3,5,+-12 V | |
Qualification Status | Not Qualified | Seated Height-Max | 3.32 mm |
Supply Voltage-Max | 5.5 V | Supply Voltage-Min | 4.5 V |
Supply Voltage-Nom | 5 V | Surface Mount | YES |
Technology | CMOS | Temperature Grade | COMMERCIAL |
Terminal Finish | TIN LEAD | Terminal Form | GULL WING |
Terminal Pitch | 0.5 mm | Terminal Position | QUAD |
Width | 14 mm |
Service Policies and Others
After-Sales & Settlement Related
For alternative payment channels, please reach out to us at:
[email protected]Shipping Method
AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.
365-Day Product
Quality Guarantee
We promise to provide 365 days quality assurance service for all our products.
In Stock: 7,072
Minimum Order: 1
Qty. | Unit Price | Ext. Price |
---|---|---|
1+ | - | - |
The prices below are for reference only.
All bill of materials (BOM) can be sent via email to [email protected], or fill below form to Quote for W83697HF, guaranteed quotes back within 12hr.